Sitemap: TAPS, DIES, DIENUTS, Drills, Reamers, Milling Cutters, Slitting Saws, Toolbits

The Tap & Die Co
445 West Green Road
London N15 3PL - UK
Tel:+44 (0)20 88881865
Fax:+44 (0)20 88884613
Email:
sales@tapdie.com
www.tapdie.com

LARGEST
On-line for
TAPS DIES Drills
or click:  ‘Products’
Established since 1978

CURRENCY Converter

SITEMAP
Technical Data

Technical Data for Taps+Dies+Drills+Reamers+Milling Cutters
MM equivalent Inch,No,Letter+Tapping Drills for Taps+Taps+Dies Terminology+Hints on Tapping+Common Tapping Faults
Drills Terminologty+Drills Guide+Drill Speeds&Feeds+Drill Regrinding+Reamers Terminology+Reamers Guide+Milling Cutters
Information+Cutting Speeds for HSS Endmills,Slotdrills+Conversion Chart SFM to RPM(Surface Feet per minute to Revolutions per minute

Useful ADVICE and  TECHNICAL information for USERS of our site
Click on any of the  TECHNICAL DATA: ‘buttons’ shown below



Click on Buttons above which show:
MM equivalent Inch,No,Letter+Tapping Drills for Taps+Taps+Dies Terminology+Hints on Tapping+Common Tapping Faults+Drills Terminologty+Drills Guide+Drill Speeds&Feeds+Drill Regrinding+Reamers Terminology+Reamers Guide+Milling Cutters Information+Cutting Speeds for HSS Endmills,Slotdrills+Conversion Chart SFM to RPM(Surface Feet per minute to Revolutions per minute

PRINT any Technical Data page you are viewing - [To help you do this, go to: File menu (click on it), click on Page Setup (in dropdown menu) - set Margins at 6mm for Left, Top, Right, Bottom - click OK. -Go back to: File menu (click on it)- click on Print - type Number of Copies required - click on Print. It will now print the information

©=copyright - ‘Technical Data’ shown in our site can be freely used.  This information must NOT
be reproduced or published in any article or website, without the written permission of:
 The Tap & Die Co, London